Safety Switch Pro TwinBatt (M6) HV Multiplex

Some details :

• Unregulated high voltage supply (input voltage = output voltage)
• SMD technology, low wear, insensitive to vibrations
• Gold contact plug system and large wire cross-section
• Very high DC transmission capacity due to efficient cooling by milled aluminum housing
• Low power loss due to "ideal" FET-simulated diodes
• Reliable battery supply via MPX M6 sockets and mounting clips
• Compact design
• Failsafe: If there is a problem with the switch or the power cords, the electronics will make sure it is in the ON position
• Two receiver power cords for doubling the cross-section and number of cantacts
• High intensity MPX M6 plugs on the SAFETY-SWITCH PRO TwinBatt (M6) for connection to MULTIPLEX RX-9/12/16-DR pro M-LINK receivers or any other receiver on the market with M6 input
• Double power supply integrated on the SAFETY-SWITCH PRO TwinBatt; the batteries are discharged at the same time and in the same way
• It is also possible to connect a BEC controller and a backup battery simultaneously. With this combination, make sure that the output voltage of the controller is higher than the voltage of the backup battery, e.g. if the BEC voltage is 8V, the backup battery discharges to 8V, then the BEC takes over. If the BEC fails, the backup battery will discharge again.
• Switch connection socket for free choice of your MPX switch (magnetic / professional safety switch /
  Micro)
• LED status display on the housing
• Possibility to connect another optional LED cord with a 3mm flat head LED for switch position display

Technical specifications:

• Dimensions: 46x44x18mm
• Weight: 55g
• No. of cells: (2x) 5 NiXX, 2S LiPo/LiIo/LiFe
• Continuous current: 35A
• Peak current : 60A
• No load consumption >0.1 A
• Receiver connection: 1x 2.5 M6 200mm
• Battery connection: MPX M6 Connector

Contents of the box:

(1) SAFETY-SWITCH PRO TwinBatt (M6) HV
(4) Fixing screws
(1) 30 cm long LED cable
(1) Operating instructions