Aerobatic Plane - EXTRA 330SX - (approx. 1.90m) - Blue white red

The Pilot-RC Extra 330SX 75″ is a radio-controlled aerobatic aircraft designed to combine precision, agility, and low-speed stability. With a wingspan of 1.90 m and a wing area of 7,194 cm², it is intended to be powered by a 30 to 40 cc gasoline engine or an equivalent electric setup.

Its airframe features a hybrid construction combining wood and composite materials to reinforce the fuselage and wings. The covering is applied on a German-made Oracover base.

The Pilot-RC quick-mount system is fitted to the wings, stabilizer, SFG, and canopy. The stabilizer can be removed without tools for easier transport and reduced setup time at the field.

The fuel tank is positioned at the center of gravity to minimize balance variations during flight. Hinges are factory-installed, glued, and pinned. The engine mounting position is laser-engraved, and the open structure makes it easy to install a canister-type muffler.

The model supports either a pull-pull or push-pull rudder linkage. The elevator halves are designed to fit standard-size servos.

Technical specifications

• Model: Extra 330SX 75″
• Type: ARF RC aerobatic aircraft
• Wingspan: 1,900 mm
• Length: 1,890 mm with spinner
• Wing area: 7,194 cm²
• Stated weight: approximately 5.6 kg
• Construction: hybrid structure in wood and composite materials
• Covering: applied on an Oracover base
• Recommended power: 30 to 40 cc gasoline engine or equivalent electric power
• Required servos: 5 high-torque servos of at least 20–21 kg
• Control setup: one servo per aileron, one servo per elevator half, and one rudder servo
• Additional servo: one throttle servo for gasoline engines
• Spinner diameter: 3.5 inches, or about 89 mm
• Recommended initial center of gravity: 128 mm behind the leading edge, at the fuselage

Included items

The kit notably includes:

• the pre-fabricated and covered airframe;
• the carbon fiber main landing gear;
• the tail gear;
• the wing joiner tubes;
• the fiberglass control horns;
• wheels, axles, and wheel pants;
• a clear lower cowl section for cutting template;
• factory-installed hinges;
• the pre-installed canopy;
• the prepared fuel tank and tubing;
• the filling valve and tank vent;
• pre-made linkages with ball joints;
• a matching 3.5-inch carbon spinner.

Additional equipment required

To complete and fly the model, you will also need:

• a 30 to 40 cc gasoline engine or an equivalent electric power system;
• five high-torque servos of at least 20–21 kg;
• an additional throttle servo for gasoline engines;
• a transmitter and receiver;
• a propeller;
• appropriate batteries;
• a power management system;
• servo extensions;
• the necessary accessories for installing your chosen power system.