Voltige Aircraft - PilotRC - SBACH342 - (approx. 2.63m) - green grey black white

The Pilot-RC Sbach 342 V2 103″ is a large-scale radio-controlled aerobatic aircraft. This new generation combines the smooth handling of the previous 107″ Sbach 342 with the performance required for modern Xtreme Aerobatics.

With an exact wingspan of 2.647 m and a wing area of 12,100 cm², it is designed to accommodate a 100 to 130 cc gasoline engine or an equivalent electric power system.

Its airframe uses a hybrid construction combining wood and composite materials to reinforce the fuselage and wings. The covering is applied on a German-made Oracover base.

The Pilot-RC quick assembly system is fitted to the wings, stabilizer, and canopy. The stabilizer can be removed without tools to simplify transport and reduce preparation time at the field. The main landing gear can also be disassembled into two independent parts.

The hinges are installed, glued, and pinned at the factory. The engine mounting position is laser-engraved. The engine cowl is fixed from the inside to keep the exterior surface free of visible screws. The open structure also makes it easier to install canister-type mufflers.

Technical specifications

• Model: Sbach 342 V2 103″
• Type: ARF acrobatic RC airplane
• Wingspan: 2,647 mm
• Length: 2,603 mm with spinner
• Wing area: 12,100 cm²
• Declared weight: 12.9 kg
• Construction: hybrid structure of wood and composite materials
• Covering: applied on Oracover base
• Recommended power: 100 to 130 cc gasoline engine or equivalent electric system
• Servos required: 7 high-torque servos
• Aileron configuration: two servos per aileron
• Elevator configuration: one servo per elevator half
• Rudder configuration: one servo
• Additional servo: one throttle servo with gasoline power
• Spinner diameter: 5 inches, or 127 mm

Included items

The kit includes in particular:

• the pre-built and covered airframe;
• the main landing gear in carbon fiber;
• the tail gear;
• the wing joiner tubes;
• the fiberglass control horns;
• the wheels, axles, and wheel pants;
• a clear lower cowl section as a cutting template;
• the installed hinges;
• the preassembled canopy;
• the prepared fuel tank and tubing;
• the fuel fill and vent fittings for the tank;
• the prepared linkages with ball joints;
• a matching 5-inch carbon spinner.

Additional required equipment

To complete and fly the model, you will need to provide:

• a 100 to 130 cc gasoline engine or equivalent electric power system;
• seven high-torque servos;
• an additional throttle servo with gasoline power;
• a transmitter and receiver;
• a propeller;
• suitable batteries;
• a power management system;
• servo extensions;
• the necessary accessories for installing the chosen power system.