

SAFETY FIRST! With the Futaba Dual Link Power Hub DLPH-1, you quadruple the safety of your model by running two S.BUS/S.BUS2 receivers and two batteries in parallel. If there is a problem with the main receiver or one of the batteries, the DLPH-1 switches to the second receiver or battery in a flash. But the DLPH-1 can do so much more...
The Futaba Dual Link Power Hub DLPH-1 is designed for the high current supply of Futaba S.BUS receivers and normal servos as well as S.BUS/S.BUS2 servos. The servos are connected to the corresponding servo outputs on the DLPH-1. These supply the servos with power, position and control signals. Only one connection cable between the DLPH-1 and the receiver is required for powering the receiver itself and for signal transmission.
If several servos are to be operated at the same time with a lot of power and/or at high speed, this basically poses a problem for the supply of the servos, since power and speed always go hand in hand with high power requirements.
This required power cannot be sufficiently supplied to the battery via the individual plug-in connection directly at the receiver, which leads to a "bottleneck" for the required servo power.
If necessary, the voltage drops, the servos become weaker or slower or both. In the worst case, they even stop and the receiver fails.
Depending on the required power. When using the Futaba Dual Link Power Hub DLPH-1, the power flows directly from the DLPH-1 to the servos.