Aerobatic Aircraft - PilotRC - EXTRA NG-90 - (approx. 2.29m) - green white grey

The Pilot-RC Extra NG 90″ is a radio-controlled aircraft designed for precision aerobatics and 3D flight. With its wingspan of 2.29 m and wing area of 9,224 cm², it is intended to be equipped with a 50 to 76 cc gas engine or an equivalent electric setup.

Its airframe combines a wooden structure with composite elements that reinforce the fuselage and wings. The covering is applied over a German-made Oracover base.

The model features the Pilot-RC quick assembly system for the wings, stabilizer, SFGs, and canopy. The wings and stabilizer are removable to facilitate transport and storage. The removable canopy also makes battery access easier in an electric configuration.

The hinges are factory-installed, glued, and pinned. The engine mounting position is laser-engraved. The engine cowl is attached from the inside, with only two screws accessible under the fuselage. The open structure makes installing a canister-type muffler easier.

Technical Specifications

• Model: Extra NG 90″
• Type: ARF RC aerobatic airplane
• Wingspan: 2,290 mm
• Length: 2,190 mm
• Wing area: 9,224 cm²
• Stated weight: approximately 9.14 kg
• Construction: hybrid structure of wood and composite materials
• Covering: applied over Oracover base
• Recommended power: 50 to 76 cc gas engine or equivalent electric power
• Required servos: 5 high-torque servos
• Control configuration: one servo per aileron, one servo per elevator half, and one servo for the rudder
• Additional servo: one throttle servo for a gas engine setup
• Spinner diameter: 4 inches, approximately 102 mm
• Initial CG indicated: 197 mm behind the leading edge, at the fuselage

Included Items

The kit notably includes:

• the pre-fabricated airframe;
• the carbon fiber main landing gear;
• the tail gear;
• the wing joiner tubes;
• the fiberglass control horns;
• the wheels, axles, and wheel pants;
• the installed hinges;
• the pre-assembled canopy;
• the prepared fuel tank and lines;
• the fuel fill and tank vent fittings;
• the pre-made linkages with ball joints;
• a matching 4-inch carbon spinner.

Additional Required Equipment

To complete and fly the model, you will also need:

• a 50 to 76 cc gas engine or equivalent electric power setup;
• five high-torque servos;
• an additional throttle servo for gas engine setup;
• a transmitter and receiver;
• a propeller;
• appropriate batteries;
• a power supply system;
• servo extensions;
• the necessary accessories for installing your chosen power system.