GO-1020MG (0.08s/60°, 7.5kg.cm)

Servo type Digital

Thrust at 4.8V [kg/cm] 5

Thrust at 6.0V [kg/cm] 5.8

Thrust at 7.4V [kg/cm] 6.8

Thrust at 8.4V [kg/cm] 7.5

Speed at 4.8V [s/60st] 0.13

Velocity at 6.0V [s/60st] 0.11

Velocity at 7.4V [s/60st] 0.09

Speed at 8.4V [s/60st] 0.08

Servo gears Metal

Ball bearings 2×

High voltage Yes

Power supply [V] 4.8 - 8.4

Length [mm] 23

Width [mm] 12

Height [mm] 28.4

Weight [g] 20

Suitable for airplanes, helicopters, passenger cars, boats

Programmable functions

Servo Angle: Allows you to set the maximum servo travel. The default setting is about 120° for normal control pulse width (900~2100 µs); about 180° for maximum allowable control pulse width (500~2500 µs).

Servo neutral: Set the neutral (center) position of the servo.

Damping Factor: Defines the characteristics of the servo's stopping behavior.

PWM Power: Sets the power output of the servo. The higher the value, the faster the servo and the more thrust it has - of course the current consumption will be proportionally higher. Value range: 39.2~100%.

Sensitivity: Sets the sensitivity (insensitivity bandwidth) of the servo. The higher the value, the narrower the insensitivity bandwidth - the servo will only move if the change in control signal width is greater than the insensitivity bandwidth. Setting the sensitivity value too high can cause the servo to oscillate in some applications. Range: Ultra High (Extra High - approx. 1 µs sensitivity bandwidth) - High (approx. 2 µs) - Medium (approx. 3 µs) - Low (approx. 4 µs)

Soft start: Enables/disables the soft start function. This function prevents the servo from abruptly moving to the operating position after power up, thus reducing the risk of damage to the servo gears.

Reverse: Reverses the direction of servo movement.

FUTABA SR Mode: Used only with the FUTABA RC system operating in SR Mode. Do not enable this option if you are using a different FUTABA RC system setup or another brand of RC system.

SANWA SSR Mode: Used only with the SANWA RC system operating in SSR mode. Do not enable this option if you are using a different SANWA RC system setting or another brand of RC system.

Fail-safe: If the control signal from the receiver is completely lost or the servo cannot detect the signal properly (e.g. due to interference), the servo can enter one of three fail-safe modes:

(a) Free: The failsafe is disabled.

(b) Position hold: The servo holds the position corresponding to the last correctly received signal.

(c) Transition to neutral: The servo returns to the neutral position (1500 µs pulse width).

Overload protection: Enables or disables the three-stage servo overload protection - once the overload has lasted for a preset time (in seconds), the servo output power is limited to the corresponding preset value (in % of the maximum power).

Reset: Resets the connected servo to its factory default settings.