• New
MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear
  • MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear
  • MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear
  • MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear
  • MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear

MATRIX 73" 1.80m jet with Pilot RC electric retractable landing gear

After the success of the Predator Jet, here's the NEW sport jet for a new era. The Pilot-RC Matrix is an innovative approach to a new sport jet. Everything aerodynamic has been tested and learned from the Predator, and developed with one of the world's best pilots for Matrix performance. We can therefore say that this is the best sports jet ever designed, with ultimate flight characteristics for precise acrobatics. All the Matrix's features and the shape of the airframe were designed by one of Aircraftstudiodesign's top designers, Mirco Pecorari, much like the charismatic styling of hypercars.

Read more
€2,082.50
Quantity :
Stock available

  • Paiement sécurisé Paiement sécurisé
  • Livraison 24/48h Livraison 24/48h
  • Paiement 3X Paiement 3X
Cheaper elsewhere?

FEATURES :

  • Extremely lightweight full composite construction, specially designed for exceptional sport flying.
  • Painted on the outside of the mold, so no seam lines.
  • Ultra-light landing gear, the 1.8 m predator landing gear can also be used on the Matrix.
  • Specially designed turbine access for rapid installation.
  • Installation in the field can be carried out in seconds, thanks to the wing-mounted quick-release fasteners, without the need for tools.
  • The elevator is attached from the top, with just a few turns to tighten/loosen the bolt and install/uninstall the stabilizer.
  • The wing and elevator are removable for easy transport.
  • The equipment installation panel makes it easy to install the electronics. Most cables can be concealed.
  • Easy-to-install pre-installation tube for stab/rudder extension wire.

Hardware included:

  • Complete aeroframe (including pre-installed and painted carbon wing tubes and fiberglass control horns).
  • Servo extension leads
  • normal exhaust pipe
  • 2,000ml fuel tank (optional)
  • 250ml UAT tank
  • Pre-prepared pushrods with ball joints
  • Servo connector brackets

Hardware requirements:

  • Turbine size: 060-100N
  • x2 for flaps (minimum 16kg)
  • x1 for rudder (minimum 16kg)
  • x2 for ailerons (minimum 16kg)
  • x2 for elevators (minimum 16kg)
  • x1 for rudder (minimum 10kg)

Also requires all the usual accessories such as transmitter, receiver, batteries, power pack and possibly other small accessories.

Please note

The center of gravity is 196 mm from the leading edge of the wing at fuselage level. Measured with main tank empty, UAT full, landing gear down.

008-MATRIX-73-02
  • Span in meters : 1,80
  • Type of aircraft kit : Kit to equip
  • Material : Fiber / Composite